Page 1 of 1

Amber3 is out!

Posted: Fri Mar 01, 2019 12:24 am
by giancarlo
Free of charge to existing customers

Just to make it crystal clear, in our tech the more we sample, the better. Amber eq was not resampled this time, but fixed using all core 13 techniques. If you want closer behavior with the target you are maybe looking for more gain steps. At each upgrade we decide what to do, following suggestions. In a lot of cases we are resampling, but in order to get a good schedule for all products we have to choose the best compromise. There was no time for resampling the eq this time, we added so many other things to the suite

Re: Amber3 is out!

Posted: Fri Mar 01, 2019 3:18 pm
by phopho
You are saving the audio journey of so many music production lovers out there.
All i have to say is thank you Acustica Audio !

All the best,

Re: Amber3 is out!

Posted: Fri Mar 01, 2019 10:44 pm
by kenbobplus3db
Can you please explain the winky-eye level meter a bit better? On the channel strip it seems active when the pre-amps are switched off, on the stereo EQ it seems to be active when the pre-amp is switched in.

It would also help to have a block diagram. Input trim obviously affects level through the preamp, but doesn't affect the signal gain hitting the compressor. Is the pre-amp gain compensation immediately following the preamp- before EQ and Compression?

Thank you.