The NAT tip of the month (#5 - January 2011)

N.A.T. tips and tricks
Locked
User avatar
enriquesilveti
Expert
Expert
Posts: 2860
Joined: Sun Mar 28, 2010 9:00 pm
Location: Lodi | Madrid | Buenos Aires
Contact:

The NAT tip of the month (#5 - January 2011)

Post by enriquesilveti » Mon Jan 03, 2011 10:54 pm

Sampling an AD-DA loop expert settings

Tone tab
General Section
-Template: to select the deconvolution template.
-Type: to select the type of model to sample.
-Length: to select the Volterra test tone length.
-Rate (Hz): to select the sample rate .

Dynamic section
-Repeats: to select sampling repeats.
-Space(s): to select how many seconds of space between Volterra test tone.
-Number: to select how many Volterra test tone will played.
-Steps (dB): to select the level between those Volterra test tones.
-Cut (Hz): to select the frequency of a Hi pass filter for real space sampling.
-Stone: enable STONE in deconvolution tab.
-Untitled check box: to enable second upper Volterra test tone.
-Number: to select how many Volterra test tone will played.
-Steps (dB): to select the level between those Volterra test tones.

Variant Section
-Loop(s): to select the loops for time variants model sampling.

Deconvolution tab
General section
-Algorithm: to select the type of deconvolution algorithm.
-64 bits: to select 64 bits float instead of 32 bits float.
-Normalize: to enable deconvolution normalization.
-Mono: to enable one input sampling.

Stone section
-Amount: *
-Linearity: *
-Phase Locked: *

Kernels section
-Max Order: to select the maximum amount of kernels for deconvolve.
-Dir (ms): to select the length of each kernel in direct convolution.
-Ftt (ms): to select the length of each kernel in FFT convolution.

* Will be explained in another NAT tip.
Attachments
Sampling an AD-DA loop expert settings 01.jpg
Sampling an AD-DA loop expert settings 01.jpg (76.21 KiB) Viewed 3517 times
Sampling an AD-DA loop expert settings 02.jpg
Sampling an AD-DA loop expert settings 02.jpg (71.16 KiB) Viewed 3517 times

Locked