If I want to render some 44.1 wavs, but the presets I want to use are at 96, do I need to upsample the wavs first, or does renderer work it all out?
Additional software tools
2 posts • Page 1 of 1
Loki, I believe your host is doing that. If the frequency rate says 96,000hz, it should have 44.1 hz to the right of it. If it doesn't and there is a blinking symbol, you have to go to the bottom and click on the mast page, you will see rate cnv and a number in ms after that,(located lower right, second entry above). It has to be above 3200ms, mine originally had like 25.3ms. I used one of the faders to increase the amt. I don't remember which fader as I have neb2 and they aren't labeled. I believe the 44.1hz is the freq rate of the host, or what the 96,000hz is being converted to, if it says 48.1hz, then I assume the host is setup for that rate and you would need to change the host to 44.1hz if that was the case. I got the 3200ms number from another post somewhere here on the forum.