8 posts • Page 1 of 1
For some reason I have a problem when trying to use a reverb session. After it finishes running the test and deconvolving the impulse will not work correctly. I know that the sine waves are being sent to my box because I can plug in the phones and it sounds completely wet. I turned the reverb up to 100% and the direct signal to 0%. The problem that I get is that I have a completely dry program where the fx fader only increases the signal and there is no reverberation at all. Any suggestions?
they are wet. They have long gaps of time in them though between sweeps. I hear crackles on some of the sweeps at the high frequency range though. I'm not sure if I accidentally clipped the input or if it is a latency issue r crappy guitar effects. Maybe instead of trying a guitar hardware reverb I should use a different one. I'm just wanting to do this one as a test to figure out if I have latency issues as my hardware seems to jump around when I do test. I'm using an e-mu 1212M.
I need to figure this stuff out really soon too, at least if I'm going to sample some of my school's equipment. They have a groove tubes Vipre and a Great River preamp that are nice. They also have the S*L lunchbox as well but I believe that that has already been sampled somewhere. Is this correct?
purpose of this test is to get a wet signal, when it fails the test failed!!!!! you should NEVER get a dry program. If it happens, it's not a bug. It means you are sampling the direct signal in some way. Sometimes it happens because in the audio driver someone configured the direct monitoring feature: for example input1 is monitored in outputs for some way. Sometimes you are routing it using an external mixer and so on. Good hunting!
other tip: use nebula reverb only for playing your program, before increase the tail size for FREQD in the MAST page. Listen carefully recorded wav files (you'll find it in the folder created by nat). A wet sinesweep is incredibly wet. Otherwise post it (zip it, it will be rather small).