Thanks for the detailed answer!
Fishmac wrote:Hi everyone!
This library was sampled with very superb equipment (Prism converters, vovox cables, etc.), so the SRC shouldn't be a problem when used at higher rates.
I was wondering about the percentage values as well, but the reason it was chosen instead of db values is - you could not believe the db values. Like the original unit, these programs will give you different peaks depending on the bandwith. There is a maximum of 20 db, which you get on 100% bandwith settings. But if you lower the bandwith, the amount of gain will differ. This is one reason why this eq is so different to other parametric concepts and of course is also a reason why it sounds so musical and smooth.
The same goes for the shelf filters. The amount of bandwith controls a boost at the frequency its set here, so you can go from a regular shelving filter to a strong attentuation of the chosen frequency.
These concepts combined give you a great possibility to combine curves in a way that allows rich soundsculpting.
The answer in short: There are no db values because you could not trust them.
also just curious to any rough date fro when the compressor programs are gonna be ready i have been waiting for months!!
either the server or my bandwidh is quite slow this morning.
How dose this compare to Doc Fear?
is it possible to just delete the distortion kernals/save as new programs and make versions that are 'clean'
Thats why making a 10kernel preamp program through the device is good, so you can have one of those after your clean eq presets.
I just bought this - didn't read the requirements. Will this work with the OSX version of N3?