Running everything in Nebula Reverb

Tips & tricks, working results, technical support
User avatar
Posts: 10928
Joined: Mon Sep 21, 2009 10:40 pm
Location: Italy

Re: Running everything in Nebula Reverb

Post by giancarlo » Sun May 01, 2011 9:57 am

the only parameters you need to change in MAST page:

4) L FREQD: if you hear truncated tails in reverbs
5) DSPBUFFER: if you have too much latency (cpu load will rise)
6) RATE CNV: if nebula is not converting programs to your usual frequency rate (blinking arrows in PROG page). Loading time will rise.

apollo soul
User Level III
User Level III
Posts: 37
Joined: Sun Mar 27, 2011 12:25 am

Re: Running everything in Nebula Reverb

Post by apollo soul » Sun May 01, 2011 8:20 pm

ok, thx. Just wasn't sure if some of those other parameters might be causing any unnecessary latency or system strain.

btw... what is default value for rate conv? Each new instance sets itself to last setting, so I don't know what it used to be.

Also, what is default for LfreqD?

Post Reply